If mccullough you''re electric moving the auger chipper and shredder and mccullough more than a few feet to the next hole, electric and chipper shut off the shredder engine and restart it again with the auger resting in the next pilot hole. When you''re mccullough not using the auger, just shut it off and leave it in one of the holes, electric or rest it on the chipper ground with the spark shredder plug facing up to prevent fouling, or sideways if fuel mccullough leaks from the gas cap.For deeper holes requiring the extension electric rod (Photos 5 and 6), dig all the chipper holes first with the unextended auger. Never start holes with the extension shredder rod in place. It''s much harder mccullough to hoist a 4-ft. long auger filled with earth. electric After the holes are dug to 36 in., attach the extension rod and dig the remaining depths all at once. At times, chipper I''ve found it easier to simply dig the remaining shredder and mccullough few inches by hand rather than electric use the extension rod, especially if fatigue is setting in. Above chipper and shredder all, clear the hole frequently. It can be a gut-busting experience to lift an auger overfilled with earth free of the hole, or worse, free a stuck mccullough auger.

HULL: 212'' x 176'' x20''.VARIABLE LOAD: 1,720 t.HELIPORT: 70'' diameter.STORAGE: Mud & Cmt Bulk--222.56 cu m; LiquidMud--198 cu m; Water for Drilling--694.92 electric cu chipper m; PotableWater--302.96 shredder cu m.DRILLING EQUIPMENT: Drawworks--Nat''l 1320UE; Pumps--two mccullough and electric Nat''l 12-P-160; Primemovers--four Cat. 3516; Rotary Table--Nat''l C-375.DERRICK: 147''; 632 t.BOP SYSTEM: 21g" Hydril 2,000 chipper psi, 13 5/8" 10,000 psi.CRANES: Three 45 t.MOORING: shredder and mccullough and electric Three x 4.5 t.WORK AREA: China Sea.BOHAI NO. 10RIG DESIGN: CantileverCONSTRUCTION: Marathon chipper Le Tourneau, Singapore, 1980 shredder.

©2003 www.chippershredder.net All rights reserved.