The popularity of cowboy shooting means lots of people are working on Colt and Ruger single-action revolvers. Both of which have the easiest screws in creation to mess up. Brownells has assembled a kit that contains the very specific drivers needed for those pesky screws. For the Ruger set there are four bits and the Colt set has five, The Magna-Tip handle for them is hollowed out so the bits can be stored inside so there''s no risk of getting them mixed up with other stuff. The only fault I find is once you take them out of the package you have to count bits or study screws to separate the Colt from the Ruger. I''ll probably take a vibrating marker and fix that.

Under-hood generators typically are rated from 5kw to 10kw. The generator is located chippershreddercrary in the engine compartment and belt-driven from the engine. Power can be used while driving or stationary. The only other component to the belt-driven generator is a control box, about the size of a computer tower that needs to be located in a compartment.The PTO generator can be installed on a two-wheel drive light-duty rig if it''s equipped with a PTO opening on the transmission. This typically chippershreddercrary is offered as a manufacturer option, but it needs to be added when the vehicle is ordered. A PTO generator can''t be used on a four-wheel drive unit because of the location of the transfer case in relation to the PTO opening on the transmission.

Another important thing to consider is minimum hub thickness, which is calculated based on such factors as locking device outer diameter and surface pressure. The hub should be thicker than this value to prevent excess stress and early failure. Locking device manufacturers typically provide this formula.Andrew/Whittet-Higgins: chippershreddercrary Consider all costs of the assembly rather than the individual costs of each component.Keith/U.S. Tsubaki: Go keyless. Keys and splines weaken the shaft chippershreddercrary by chippershreddercrary cutting into it, requiring a larger shaft and accompanying parts, such as bearings, to handle the higher forces.End-user adviceWhat should END USERS do to maximize life and productivity?Carl/Ringfeder: Pay close attention to the OEM''s service instructions and use the locking device manufacturer''s technical information to help with replacement or reinstallation. Warren/Fenner: In general, locking devices don''t require any maintenance or special attention to maintain their performance and maximum life.

©2003 www.chippershredder.net All rights reserved.